ULTRABLOCK eSATA IDE / SATA (Read Write)

About the UltraBlock eSATA IDE-SATA (Read/Write)

Product Code: AP-DI-W2750
Read Write UltraBlock eSATA IDE-SATA is used to write data to an IDE or SATA hard drive.
The eSATA Forensic Bridge supports four different host connection options for SATA and IDE device acquisitions:

  • One eSATA Port
  • Two FireWire800 Ports
  • One FireWire400 Port
  • One USB 2.0/1.1 Port

UltraBlock eSATA IDE-SATA Read-Write
We offer an UltraBlock eSATA IDE-SATA pre-configured for read/write operation. It is available in a yellow case so that you can easily distinguish a pre-configured read/write device from a read-only device.

Request a Quote


    If possible, please use a valid agency/company email.

    RCMP DMFT Program?


    This is necessary to quote accurate shipping costs.



    Versatile Operation In Write Protect mode, the UltraBlock will prevent ANY and ALL writes from reaching the attached device. It is compatible with all Windows 98se, Windows ME, Windows 2K/XP, and any O/S that supports IEEE 1394 and has a compliant card and drivers. In Read/Write mode (non-Write Protected), it can be used to attach a drive to be used for receiving images on your FireWire chain. The UltraBlock is shipped by default in a Read-Write (no write blocking) configuration. However, it can be configured to enable Read-Only operation as well.

    PC Interface: eSATA, FireWire-A, FireWire-B, USB (1.X/2.0)
    Drive Interfaces: Parallel IDE (48 Bit ATA-6 Compatible), Serial ATA
    User Configurable: Read-Only or Read-Write

    Configuration Switches

    SWITCH 1 OFF = Read Only (write blocking enabled) ON = Read/Write

    SWITCH 2 OFF = Unit reports errors if writes are attempted ON = Unit suppresses errors if writes are attempted

    SWITCH 3 OFF = Unit reports Write-Protect (WP) status in code page ON = Unit suppresses Write-Protect (WP) status in code page

    SWITCH 4 Reserved

    Notes

    The UltraBlock Power Supply may only be used to power one UltraBlock and one Hard Drive. Do not attempt to use a single external power supply to power more than one UltraBlock and Hard Drive. This UltraBlock Kit includes the UltraBlock Device, UltraBlock Power Supply, eSATA cable, 9-pin to 9-pin FireWire-B (800) cable, USB cable, one drive power cable, one 9-6 pin Firewire adapter, one 9-4 pin Firewire adapter and IDE and SATA drive data cables.

    Additional FireWire-A (400), FireWire-B (800), and USB Cables are available from Digital Intelligence as required for your application.